Quantitative analysis of microstructure evolution, stress partitioning and thermodynamics in the dynamic transformation of Fe-14Ni alloy

Li, L.*; Miyamoto, Goro*; Zhang, Y.*; Li, M.*; Morooka, Satoshi; Oikawa, Katsunari*; Tomota, Yo*; Furuhara, Tadashi*

Journal of Materials Science & Technology, 184, p.221 - 234, 2024/06

https://doi.org/10.1016/j.jmst.2023.10.037

Neutron diffraction study on the deuterium composition of nickel deuteride at high temperatures and high pressures

Saito, Hiroyuki*; Machida, Akihiko*; Hattori, Takanori; Sano, Asami; Funakoshi, Kenichi*; Sato, Toyoto*; Orimo, Shinichi*; Aoki, Katsutoshi*

Physica B; Condensed Matter, 587, p.412153_1 - 412153_6, 2020/06

https://doi.org/10.1016/j.physb.2020.412153

The site occupancy of deuterium (D) atoms in face-centered-cubic nickel (fcc Ni) was measured along a cooling path from 1073 to 300 K at an initial pressure of 3.36 GPa via in situ neutron powder diffraction. Deuterium atoms predominantly occupy the octahedral (O) sites and slightly occupy the tetrahedral (T) sites of the fcc metal lattice. The O-site occupancy increases from 0.4 to 0.85 as the temperature is lowered from 1073 to 300 K. Meanwhile, the T-site occupancy remains c.a. 0.02. The temperature-independent behavior of the T-site occupancy is unusual, and its process is not yet understood. From the linear relation between the expanded lattice volume and D content, a D-induced volume expansion of 2.09(13) atom was obtained. This value is in agreement with the values of 2.14-2.2 atom previously reported for Ni and Ni Fe alloy.

Synthesis and characterization of nickel-copper hydroxide acetate, NiCu(OH)(OCOCH) 0.9HO

Kozai, Naofumi; Mitamura, Hisayoshi; Fukuyama, Hiroyasu; Esaka, Fumitaka; Komarneni, S.*

Microporous and Mesoporous Materials, 89(1-3), p.123 - 131, 2006/03

https://doi.org/10.1016/j.micromeso.2005.10.015

Layered transition metal hydroxide salt (LTMHS) is a group of anion-exchangeable layered compounds. Although LTMHSs have recentely attracted attention of researches on anion exchange and intercalation, very limited numbers of reports have been published on their synthesis, characteristics, and applications. This paper describes basic characteristics of a new LTMHS, nickel-copper hydroxide acetate. Hydrothermal Heating of an aqueous solution containing nickel acetate, copper acetate, and hydrogen peroxide to 150C for 4h yielded a layered compound with an analytical composition of NiCu(OH)(OCOCH) 0.9HO. This compound does not take up Cl and NO in aqueous solution but takes up multivalent anions and shows high selectivity in uptake of toxic SeO and AsO. This compound may find applicarion in the removal of those toxic anions form natural water and wastewater rich in Cl and NO.

Development and installation of thermal diffusivity measurement apparatus for minor actinide compounds (Contract research)

Nishi, Tsuyoshi; Takano, Masahide; Ito, Akinori; Akabori, Mitsuo; Minato, Kazuo; Kizaki, Minoru

JAERI-Tech 2005-051, 13 Pages, 2005/09

JAERI-Tech-2005-051.pdf:1.38MB

An apparatus has been developed to measure the thermal diffusivities of minor actinide (MA) compounds. By installing the laser flash apparatus in a glove box with highly purified inert gas atmosphere, the thermal diffusivities measurement of MA compounds of -decay nuclides was enabled. A new sample holder has been also developed to measure the thermal diffusivities of very small samples. The performance of this new apparatus was confirmed by measuring the thermal diffusivities of small samples of tantalum, nickel and cerium oxides. The thermal diffusivity values obtained in this work agreed well with the literature values and the values measured by a conventional thermal diffusivities measurement apparatus. Accordingly, this apparatus was found to be useful for thermal diffusivities measurement of MA compounds.

Characterization of rust layer formed on Fe, Fe-Ni and Fe-Cr alloys exposed to Cl-rich environment by Cl and Fe K-edge XANES measurements

Konishi, Hiroyuki; Yamashita, Masato*; Uchida, Hitoshi*; Mizuki, Junichiro

Materials Transactions, 46(2), p.329 - 336, 2005/02

https://doi.org/10.2320/matertrans.46.329

Chloride in atmosphere considerably reduces the corrosion resistance of conventional weathering steel containing a small amount of Cr. Ni is an effective anticorrosive element for improving the corrosion resistance of steel in a Cl-rich environment. In order to clarify the structure of the protective rust layer of weathering steel, Cl and Fe K-edge X-ray absorption near edge structure (XANES) spectra of atmospheric corrosion products (rust) formed on Fe, Fe-Ni and Fe-Cr alloys exposed to Cl-rich atmosphere were measured. The Fe K-XANES measurements enable the characterization of a mixture of iron oxides such as rust. The chemical composition of the rust was determined by performing pattern fitting of the measured spectra. All the rust is composed mainly of goethite, akaganite, lepidocrocite and magnetite. Among these iron oxides, akaganite in particular is the major component in the rust. Additionally, the amount of akaganite in the rust of Fe-Ni alloy is much greater than that in rust of Fe-Cr alloy. Akaganite is generally considered to facilitate the corrosion of steel, but our results indicate that akaganite in the rust of Fe-Ni alloy is quantitatively different from that in rust of Fe-Cr alloy and does not facilitate the corrosion of steel. The shoulder peak observed in Cl K-XANES spectra reveals that the rust contains a chloride other than akaganite. The energy of the shoulder peak does not correspond to that of any well-known chlorides. In the measured spectra, there is no proof that Cl, by combining with the alloying element, inhibits the alloying element from acting in corrosion resistance. The shoulder peak appears only when the content of the alloying element is lower than a certain value. This suggests that the generation of the unidentified chloride is related to the corrosion rate of steel.

Development of scintillator for a high-frame-rate neutron radiography

Matsubayashi, Masahito; Katagiri, Masaki

Nuclear Instruments and Methods in Physics Research A, 529(1-3), p.389 - 393, 2004/08

https://doi.org/10.1016/j.nima.2004.05.017

no abstracts in English

Electro-deposition of tantalum on tungsten and nickel in LiF-NaF-CaF melt containing KTaF; Electrochemical study

Mehmood, M.*; Kawaguchi, Nobuaki*; Maekawa, Hideki*; Sato, Yuzuru*; Yamamura, Tsutomu*; Kawai, Masayoshi*; Kikuchi, Kenji

Materials Transactions, 44(2), p.259 - 267, 2003/02

https://doi.org/10.2320/matertrans.44.259

Electrochemical study has been carried out on the electro-deposition of tantalum in LiF-NaF-CaF melt containing KTaF at 700C. This has been done for determining the mechanistic features for preparing electrolytic coating of tantalum on nickel and tungsten substrates. Electro-deposition of metallic tantalum occurs primarily by electro-reduction of Ta(V). Pure metallic tantalum without any entrapped salt is successfully deposited on tungsten by galvanostatic polarization at reasonably low current densities. An additional feature on nickel is the formation of an intermetallic compound at potential 0.25V nobler than that of pure tantalum as a result of underpotential deposition of tantalum. This intermetallic compound covers the surface within a short time followed by deposition of pure tantalum, although intermetallic compound keeps growing at the interface of pure tantalum deposit and the substrate as a result of diffusion.

Tritium permeation behavior implanted into pure tungsten and its isotope effect

Nakamura, Hirofumi; Hayashi, Takumi; Kakuta, Toshiya*; Suzuki, Takumi; Nishi, Masataka

Journal of Nuclear Materials, 297(3), p.285 - 291, 2001/09

https://doi.org/10.1016/S0022-3115(01)00635-3

The isotope effect on the implantation-driven permeation of pure tritium (T) and deuterium (D) through nickel was investigated, respectively. The rate-determining processes of backward flow at the upstream surface and permeation at the down-stream surface were found to be as follows: recombination on up-stream surface and diffusion at down-stream side in a lower temperature region, whereas recombination on both surfaces in a higher temperature region for T and D, respectively. The diffusion coefficients of T and D derived by analyzing the obtained transient data of permeation in the lower temperature region were in good agreement with literature data of deuterium. The obtained activation energy of diffusion for T and D suggested the tendency of mass dependence. The surface recombination coefficients for both isotopes were also derived and showed in good agreement with literature data. As a result, the experimental results indicated the surface recombination could be attributed to the isotope effect of the permeation between T and D rather than the diffusion.

Chemical states of oxygen implanted in SUS 304 stainless steel and pure metals studied by XPS using synchrotron radiation

Li, Y.; Baba, Yuji; Sekiguchi, Tetsuhiro

Journal of Materials Science, 35(24), p.6123 - 6130, 2000/12

https://doi.org/10.1023/A:1026792103075

no abstracts in English

Determination of acid soluble and insoluble boron in nickel-base heat resistant alloys by curcumin spectrophotometry

; Watanabe, Kazuo

Bunseki Kagaku, 42, p.T43 - T47, 1993/00

https://doi.org/10.2116/bunsekikagaku.42.3_T43

no abstracts in English